Simple File Networking Problem
I have 2 HD210 Media Players that I am tring to get to work on our network. When I first received the units I took unit #1 and created an HDMI sample project to it and everything seemed fine. I am now trying to setup the units on the network I first created a VGA project published to the SD card on Unit #1 and it displayed fine on a VGA display(i am using a VGa display because the 52 inch display's with HDMI aren't mounted yet). I then followed the Setup a unit under the Tools menu and filled all of the network information and created the setup SD card and then inserted that into unit #1 and nothing displayed and I couldn't even ping the the unit and the Cisco Switch didn't even see a MAC address on the port. I then found information "Manual IP Configuration" and downloaded the autorun.brs file and modified it with our correct network information with the same results. I then took the unit #2 out of the box and then inserted the same SD card and the VGA display had on it "Manual Network Configuration" and at the end displayed "Settings Updated. Remove Network Configuration Script from flash card". I am now able to ping unit #2 but it still is not loading the presentation from the IIS weberver. I suspect something is not setup correctly on the web server. Is there a way to turn logging on so that I can figure out what is happening? Also unit #1 still does not display anything on the screen when the Manual IP Configuration script is run. I published a VGA formatted display to the SD card and it appears to display this correctly. Any idea what is wrong with this unit? Can the unit be restored to factory defaults? I noticed a recessed button on the side labeled GPIO12. What is this button for? Any help would be appreciated.